We offering finest quality Steel Frame Roll Forming Machine
to clients. This is the fastest machine on the market. The newly servo
drive punch simultaneously advances and punches with accuracy as the
material continually moves through the machine. Not only does this
considerably increase the speed of the roll forming machine, but also
increases the life of the equipment tools.
Entry gate will be provided for movement of sheet to roll former.
Main Base
The main base is MS fabricated structure and adequately ribbed to minimize the distortion. It is accurately machined on top and bottom surfaces the threaded holes are made on the bed for positioning the stands.
Mill stands (Station)
The stands are mounted on the bed of the machine the line alignment can be easily done due to guide ways arranged on the bed of the machine. Each forming head consists of a fixed housing and sliding type out board housing. The mill stands will be arranged to locate shafts mounted on taper bearings. For the top shafts the bearings are housed in the cartridge type bearing blocks. The bottom shaft bearings are located in the bored machined in the housings. The bottom arbors are fixed in position whereas the top arbors along with cartridge blocks could be raised or lowered in vertical guides machined in housings.
- De coiler 2 ton cap.
- Entry Gate with
- Roll Forming Machine with 9 station, 1 Gear Boxes & 3H.P. electrical.
- Control Panel semi auto
- Cutting Unit
- Maximum sheet width that can be formed : 175mm
- Maximum sheet thickness in CRCA Strips that can be formed : 1 mm
- Vertical distance between shafts : 80 mm
- Horizontal distance between shafts : 175mm
- Number of forming stations : 9 nos.
- Vertical station : 7 nos.
- Total HP for Line : 3(ABB)
- Speed of the machine : 4mt/minute
- Size of machine : 1600 x 800 x 1100 mm
- Coil weight : 2 MT Max
- Coil width : 90 MM
- Coil bore : 450 MM min, 510 MM max dia.
- Mandrel movement : Manually adjusted
- Back Tension : Manually adjusted
Entry gate will be provided for movement of sheet to roll former.
Main Base
The main base is MS fabricated structure and adequately ribbed to minimize the distortion. It is accurately machined on top and bottom surfaces the threaded holes are made on the bed for positioning the stands.
Mill stands (Station)
The stands are mounted on the bed of the machine the line alignment can be easily done due to guide ways arranged on the bed of the machine. Each forming head consists of a fixed housing and sliding type out board housing. The mill stands will be arranged to locate shafts mounted on taper bearings. For the top shafts the bearings are housed in the cartridge type bearing blocks. The bottom shaft bearings are located in the bored machined in the housings. The bottom arbors are fixed in position whereas the top arbors along with cartridge blocks could be raised or lowered in vertical guides machined in housings.
No comments:
Post a Comment